Answer / pillay

Most importantly the insulation and HV holding test is done on
all the installations.
on the tx former;winding insulation test,
ratio test, vector group test,impedence test, oil dielectric and
other test,
bucholtz relay test, all protective equipments operation test,the
switchgears insulation and conductivity tests along with pressure
tests on cables also . all tests have to meet the local
requirements or as relevant BS.

Pls anyone explain me the basics of wiring a house?

3 Answers  

---

will 1050kva DG set withstand for back charge of 16MVA transformer

0 Answers  

---

what is the installation process for lifts

0 Answers   DLF,

---

Why Capacitor & ignator used in MH lamp

2 Answers   Bell,

---

Tell me in detail about c.t. And p.t. ?

0 Answers  

---

why the measure taken in multiplication factor of 11for voltage like.. 110V,220V,440V,1.1KV,6.6KV,11KV,33KV,66KV,110KV,132KV,220KV

1 Answers   Vijai Electricals,

---

We have studied about many techniques for finding the stability of system, ROOT LOCUS, ROUTH, BODE PLOT, POLER PLOT etc. In these which is used where. what are the difference among them... PLZ tell me.......

0 Answers   MSEB,

---

why dc series motors never start without some load, and what will happen if starting with out load..

1 Answers  

---

What is the inside of ACB & VCB & SF6 breaker's pls tell me about this

2 Answers   Standard Chartered,

---

Can anybody please refer the best and simple book for about Protection relays and in detail of all its protection ?

0 Answers  

---

int a,b ; a=b=10 ; if(a>b){ printf ("%d",a)}; no error output is a=10

2 Answers   TCS,

---

For a 50MVA (138/69/13.8 KV) transformer, what would be the maximum demand in order not to exceed 80% of its operating capacity.

2 Answers  

---