Answer / victorvgp

r u sure in this question?
if rotor is delta connected then, why slip rings r there?

Answer / nagraj

senseless quetion.. how can u brought the slipring
connections from delta connected rotor

Answer / velusamy

can u tell me the details of motor which has delta
connected rotor ?. If so, there should be atleast six slip
rings instead of three and i did not experience such type
of motors in my 15yrs of experience.

Answer / sandeep vishnoi

first of u have to think why we use star connection and why
we use delta connection .in star starting current
reduced .ok to if u want to increase starting current than
its connect in delta.if u connect rotor in delta than there
is no need of slip ring.



sandeep vishnoi
simbhaoli

Answer / felixraj

very good question
the question was not clear .its nothing but wound rotor it
will RAN but the eff depends on Z

Answer / felixraj

no need of slip ring(dela-closed path)

Answer / manoj kumar tiwari

if rotor connectionis in delta.delta connection forms a
closed path,so no necessity to short the slip rings

Answer / gurunayk

Its not necessory.....bcz windings already got shorted....
reas star delta starter from B.L.Theraja

As we know induction squirrel cage motor torque Directly praprortinal to applied voltage in star connection & delta also. If I connect 55KW Motor to DOL starter in load condition does motor withstand the load & what will be the current withdrawn ? motor will not fail ?

0 Answers  

How to select earthing strip for 100kw induction motor ?

2 Answers  

What are the advantages of DOL starter?

7 Answers  

What are the advantages of nichols chart?

0 Answers  

How we select the vector group of 3phase power transformer?

0 Answers   wbsedcl,

Why the ceiling fan rotates in clockwise direction and table fan rotates in anticlockwise direction.

3 Answers   Kirloskar, MPF, Wipro,

1> what r different types of fault in cables? How will u locate and test these faults? 2> why earth wire is provided on top throughout the transmission line. why not only on towers? How much area it can protect? 3> what r different types of transmission losses? How power loss can be minimized? 4> what is the % of power loss on transmission lines?

3 Answers   IOCL,

How can we calculate single phase load into three phase load

2 Answers   Jindal, Tanfac,

1 HT service how many LT Service

1 Answers  

Why dry type cast resin transformers tap link blast in HV side while power shut down times on load?

0 Answers  

could i arrange a faulty and healthey battery bank togather in parallel , if your ans is not then why?

3 Answers  

Why heat produce in AC machine higher than DC machine?

2 Answers