why is 555 timer called so?
Answers were Sorted based on User's Feedback
inside the 555 timer, there are 3 resistors used in series to get vcc/3 and 2*vcc/3 ....
all the 3 resistors used are same and are 5k ohm resistors..
so its called 555 timer..
acknowledgement guys ... am kinda sure though, but plz verify it ...
--RO--
| Is This Answer Correct ? | 200 Yes | 20 No |
Answer / khan mohd altaf
Becoz in that circuit 3 Resisters are used of Same value of 5k ohm in series.
| Is This Answer Correct ? | 76 Yes | 13 No |
Answer / ajay kumar yadav
The 555 timer IC was first introduced around 1971 The 555
gets its name from the three 5-kOhm resistors used in
typical early
| Is This Answer Correct ? | 79 Yes | 18 No |
Answer / sudha kumari
as i thought 555 timer is called so because of the fact that it consist three 5Kohm resistor in series and with the help of these resistors there is a delay of time and also other fact which make it timer is that timing of the pulses can be controlled through this.It basically works as a clock timer.............................
I hope its the perfect answer..............
| Is This Answer Correct ? | 30 Yes | 6 No |
Answer / sanjeev kumar
IC 555 is named as timer, it is one of the most useful ic
in electronic circuit. It consist of 3 resisters having the
capacity of 5kohm each, and with the help of these
resisters it can create a time delay, so it is called timer.
| Is This Answer Correct ? | 22 Yes | 9 No |
Answer / ajay
The 555 timer is an integrated circuit (chip) implementing
a variety of timer and multivibrator applications.The 555
gets its name from the three 5-KΩ resistors used in typical
early implementations.
| Is This Answer Correct ? | 11 Yes | 8 No |
Answer / devendra patel
dekho baat zara aise hai ki 555timer mein hot to kachu nai
hai mano 3resistor se hot hain . aur be apne matlab ki
series mein jude rehat hain .aur 1 aur baat zara ja hai ki
be jo resistor hain kaho to unki aukat 5kohms ki hot hai
jaa ke mare bahein 555 timer kehat hain
kai answer keso lago dekho bhai lage kaiso bhi mano sahi hai
| Is This Answer Correct ? | 37 Yes | 35 No |
Answer / syncopator
The 555 produces pulses. These may be a single pulse, in
monostable mode, or a series of pulses in astable mode.
The duration of the pulses, and the interval between them
in astable mode, can be controlled as desired.
In other words, the timing of the pulses can be
controlled.
| Is This Answer Correct ? | 9 Yes | 7 No |
Answer / nishi bhemani
As ic has 3 5kohm resistors connected in series to form a potential divider network to get 2/3 Vcc and 1/3 Vcc supplied to the two opamps
| Is This Answer Correct ? | 3 Yes | 1 No |
Answer / gaurav
Because in ic 555 there are
three resistor in 5ohms
connected in series
| Is This Answer Correct ? | 3 Yes | 5 No |
Explain what is the difference between plc and dcs?
What are the basic logic gates?
What is the need of Super heterodyne tuning in AM receivers?? Q - factor problem also arise at RF amplifier tuner also???
What are the maintenances of a DCS ?
tel me the diffference between transistor and bios
Can you please send me the previous 10 years solved question papers of GATE ?
What is the effect of temperature on the reverse saturation current of a diode?
List out the direct type adcs.
Each Electronics Exchange operates on -48 volt. What is the reason that exchange operates only -48 volt DC?
What is the need for base values?
write a c program to find the multiples of 5 usin arrays
behaviour of capacitor & inductor in ac circuits at t=0 & t=infinity.
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)