Answer / ram

If you are asking about the silica gel.

If its blue means its in good condition
If its Pink means it has observe moisture from air and need
to take out dry it and refill it in breather or you can
change it.

Answer / victorvgp

Sorry, i make a mistake. Question is
WHAT ARE THE COLOUR'S AND THEIR INDICATIONS IN SILICA GEL.

Answer / joshykollam

Your question contains two parts
1. what are the colors of silica gel
Silica gel available in Blue and Orange color
2 what are their indications
While Blue changes to White means it absorbed moisture
Again changed to Redish Pink colour need to Replace.
While Orange changes to white colour it absorbs moisture
Again changes to Green colour need to replace

Answer / gunasekaran

green colours indicates service position
red colours indicates test position.

what is ASCR cable and where we use it?

6 Answers   BSL,

---

11kv = LT 440v , how many amp.supose 440v side 5000 amp curent drown

2 Answers   Motwane,

---

why high current produce in case of transformer when turns are internally gets shorted.

3 Answers   TCS,

---

What is the maximum and minimum rating of UPS?

0 Answers   Indiabulls,

---

In Round type three phase transformer why the LV side is inner part and HV outer part in the design of transformer? why they cant be opposite?

2 Answers  

---

How can we increase the capacity of exixting capacitor bank??????????????? PLS. Help

1 Answers  

---

what is the higest transmission voltage and generated voltage in india

14 Answers  

---

Hi,i want to appear for IES (EEE),can any one plz help me how to apply and how to prepare

1 Answers  

---

We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?

0 Answers   Siemens,

---

how to Select Lighting arrester? What r the parameters to be considered for the selection of Lighting arrester ?

0 Answers  

---

I have been using an 600VA with 0.6 p.f UPS with my desktop which has 450W power supply unit. Can anyone explain how can this happen . Because the output of the UPS is 360W (600*0.6) (<450W)

0 Answers  

---

Do you know the faults occurs generally in motors and how to rectify them?

4 Answers  

---