Answer / harshavardhan be, me (unemploy

The power triangle is sum of (kW , kVAR, kVA) and the meter
which gives readings all of the above variables is called
TRI vector meter.
You can see the TRI vector meter installed below the
distribution transformer.
These meters are manufactured by L&T, AREVA, ABB

Answer / virendra joshi

The meter which shows 1. Active power, 2. Reactive Power
3. Apprent power called a Tri vector meter.

Answer / ramesh.a.eee

Trivector meter is Electronic type Energy Meter which
measures energy parameters, like active energy, Reactive
energy,apparent energy, Power Factor, frequency etc.
Through which we can know how much enregy recieved or
sent.Trivector meter has 2 types, one is 3ph 3wire meter n
other is 3 ph 4wire meter.
It is conneceted in the substation to incoming or outgoing
feeders to know how energy is given out or recieved from
other end, or to Transformers on HV n LV side to know the
Transformer loss.

Answer / santhiya

it consist of kvarh and kvah meter along with it and it
measures the total load kva.

Answer / amol salunkhe

the meter which gives amount of total load in kva taken by
any installation.

Answer / kamaraj

TRIVector will be able to give these many parameters,

phase voltage, ph current, power factor, reactance, line
voltage, line current, frequency.

Answer / a.mohammadmujeeb

it is device which is used to measure power
factor ,reactive power(kvar),apparent power(kwh).
and in some types it is used for multiple puporse such as
to measure voltage,current.

What Should be the value of Vector Surge angle at Tripping and how to calculate it?

0 Answers  

how to design coil turns ?

0 Answers   L&T,

how much insulation resistance 11kv & 33kv under ground cable between earth to phase & phase to phase.

4 Answers   Siemens,

suri transmission

0 Answers   Bhel,

What is the safety factor is to be consider while selecting the switchgear and protection for electrical system

1 Answers  

How to calculate VCB rating for 33KV ,25 MW Power line?

0 Answers  

What is the difference between Busbar Chambar, MCCB board and MCB Board? How to choose to use which one in the system?

2 Answers  

in 50 mw generator if field is open in full load running condition what happen and for protection which relay used?

5 Answers   century,

what is daiod

4 Answers  

My ups output shows 230 v between phase and neutral,but show zero between phase and earth.Is the system/installation is correct.If not what will be the possible reasons

4 Answers  

if the number of poles generated in stator and rotor side of an induction motor are different then what will happen and why?

0 Answers  

what is the voltage between earth to neutral in lift.

0 Answers   SIPL,