Answer / york shipley

due to the continuous operation of any diesel engine the
lubricating oil gets high temperature due to which there
will be oil vaporization and this vapor can not be allowed
to remain inside the crank case which may get high pressure and
there fore the breather/pipe is provided to send it out to
atmosphere to keep safe engine operation.

Answer / jimmy

A breather keeps the crankcase from overpressurizing.

Answer / arabinda sahoo

in the period of back compression or enngine oil vapour
takes place internal pressureof the engine increased.so
this hot gas try to go out side the engine in high
pressure.so it cointains some oil prticles .to trap the oil
particles a net is provided in the brether which is trap
the oil.so another name of brether is "oil trap ".

Answer / sagar basnet

what may be the cause that there is more pressure of air in breather outlet

Answer / asif

breather pipes are fitted with crankcase to prevent the
overpressure inside it , and fed to the open deck, thus
avoid the pressure ingressed over their!!

Answer / m.rajesh

Diesel engine runaway is a common condition affecting diesel
engine's, In many vehicles, a crankcase breather pipe feeds into

What is the PLC in (in generator maintenance side) how to it's works and what is use of that

1 Answers   Oil India, Siemens, Standard Chartered,

What is the purpose of ventilation in the battery room?

0 Answers   RRB,

a compressor running at 100 rpm gives 40% efficincy speed increase from 200 wt will be the efficincy???????????

2 Answers  

What is the differance between Quality Assurance Plan & Inspection Test Plan

2 Answers   Bureau Veritas,

tell me about a time when u had too many things to do and u were required opinion prioritized your talks

0 Answers  

Explain how the cylinder lubrication on main engine is done?

0 Answers   RRB,

hello i have a problem !!!! i am studying gait analysis"human walking; and i had only single camera"sony 25 frames/s" and 2 separated force plates, and there is no synchronization between the camera and the force plates!. i wrote a matlab program to calculate joints moment(sagital) using inverse dynamics methode. and there is a problem with the output data!! can you help me.

0 Answers  

What is ps?

0 Answers  

can any1 suggest me the books for placement papers.

1 Answers   Jindal,

Define convection.

0 Answers  

Discuss how to prepare the M/E in the standby condition

0 Answers   RRB,

what is Tensile Stress ?

7 Answers