Answer / saurabh khatri

timing belt: is a part of an internal combustion engine that synchronizes the rotation of the crankshaft and the camshaft so that the engine's valves open and close at the proper times during each cylinder's intake and exhaust strokes.

Gears are generally used for different reasons:
To reverse the direction of rotation
To increase or decrease the speed of rotation
To move rotational motion to a different axis
To keep the rotation of two axis synchronized

question related 2 soal car: Working under a bright light bulb or in direct sunlight, experiment with the angle of light hitting the solar panels. What angle gives you the fastest rotation of the wheels? How would you modify this car to make the wheels turn faster? How would you modify this design to make a car that could carry or pull a heavier load? How could you modify this design so that your car could run for short periods in complete darkness or low light situations?

1 Answers  

---

What will you check if one cylinder of your engine is not like the others?

1 Answers  

---

Explain the difference between afbc, bfbc, pfbc and pcfb in regard to fluidised bed technologies.

0 Answers  

---

HOW I SHOULD CALCULATE HEAT LOUD

0 Answers  

---

why stress decrease from upper yield point to lower yield point?

5 Answers   MahaGenco,

---

Properties of F.O. the cause damage on auxiliary boiler.

0 Answers   RRB,

---

What is a feed water pump? Dearator feed heater?

0 Answers   ABC Inc, RRB, Siemens,

---

How does a super charger work in a car?

0 Answers  

---

How do you weld 25 mm thick plate?

11 Answers   Bhel, Essar,

---

what is compression ratio? why its decreased when gear shifted ?

0 Answers  

---

What was the spinning jenny?

0 Answers  

---

What are the different types of mechanism to engage primary moving engine and transmission (in other words how many different types of clutches are there)?

1 Answers   Focus,

---