Answer / pradeep

stepper motor

Answer / sanjay chaudhary

only stepper motor used

Answer / adesh bandhu

stepper motor becoz stepper motor rotation(step) can be
contoled accordingly.

Answer / sunil parmar,nirma uni.

BRUSHLESS DC MOTOR IS THE RIGHT ANSWER

THERE ARE LARGE STEP ANGLE REQUIRED IN CPU AS PER SPEED
REQUIREMET AND IT DEPENDS ON HEATING OF DIODES IN THE
CIRCUIT OF CPU......
SO, THE STEPPER MOTOR IS USED ONLY WHERE SMALL STEP ANGLES
ARE REQUIRED....

BRUSHLESS DC MOTOR HAS LESS LOSS,LOW POWER CONSUMPTION AND
HIGH PERFORMANCE THAN STEPPER MOTOR

Answer / ayan

I THINK BRUSHLESS DC MOTOR IS DA RIGHT ANSWER.

MANY OF MY FRIENDS CHOOSE STEPPER MOTORS FOR
THEIR CORRECT ANSWER.BUT AS STRPPER MOTOR BUT
BRUSHLESS DC MOTOR.

STEPPER MOTORS ARE USED FOR SAMLL STEP SIGNALS
WHERE AS BRUSHLESS DC MOTORS ARE USED AS PER SPEED
SIGNAL AS GENERATED IN CPUs.

Answer / sherrysethi

DC brushless is the most common type used. It is quiet, and has no tendencies to produce noise signals that could interfere with the computer's operation.

Answer / niloy datta

Both answers are right..
brushless DC motor is used for cooling purposes both in
motherboard and in SMPS.
stepper motor is used in hard disc ( it needs specific
control to aquire data from disc pallet)

Answer / mani

here lot of friends says stepper motor is preffered for CPU
but sherrysethi said Breshless DC motor is used i think
this is the correct answer if any doubts pls reffer the
site (http://www.dart-creations.com/business-
tree/auto/brushless_dc_motors.html)thank you

Answer / ree

high speed spindle motor

Answer / venkates

stepper motor with rotate

Difference between 3.5 core and 4 core

2 Answers  

why lightning arrester and other equipment earthing conneting from same earth bar ?

1 Answers  

In any Industry, Which voltage level either 3.3kV or 6.6KV to be chosen? Then I would like to know ,Is there any cost consideration or Rating of motor?

5 Answers  

which relay is used for both detection & correction?(there is only one relay)

2 Answers  

Draw torque - speed curve and load curve of induction motor? mark operating point ?

0 Answers  

how we can select a transformer based on a particular load. suppose we have 4 motors of rating 40 h.p , 50 h.p, 80 h.p & 100 h.p. then what rating of transformer we can select. urgent. pls reply

6 Answers  

what is meant by MCB and MCCB? and what its full form?

7 Answers   Bajaj, JHM Hotels,

v=r*i this means when voltage increases current also increases at constant resistance.... p=v*i this means when voltage increases current decreases to maintain the power constant which one is true...

3 Answers  

Explain the difference between verilog task and verilog function?

0 Answers  

I have two PLC processors. I want to communicate both processor with each other. How i can do so?

0 Answers   IHG InterContinental Hotels Group,

why we use single core 630mm2 cable for transformer secondary side

0 Answers  

What kind of Neutral CT can be placed in 11/0.433KV transformer to be used and what are its specification?

0 Answers