How can we calculate C10 rating of a bttery from c5 or c20
ratings??
Answer / mohandas
A 100AH battery when fully charged will be discharged at a rate of 5 Amps when it is at C20 rating.
Similarly at C10 rating the battery will be discharged at a discharge rate of 10 Amps when it is at C10 rating.
It will be the same way when the battery is being charged. At C 20 rating the battery will take 20 hrs to get fully charged at a charging current of 5 Amps.
However, these are theoretical assumptions and could vary with life of the battery.
Is This Answer Correct ? | 0 Yes | 0 No |
If the 11 KV supply is fail. what will happened with it's breaker if it is supplay to the 11KV motor?
4-Why we measure the insulation resistance of main core and frame in spite of that must be connected with ground before energize the transformer?
WHAT ARE THE DISADTAGES OF SINGLE-WIRE-EARTH-RETURN SYSTEM USED FOR RURAL ELECTRIFICATION?
who is make controlling in the reactive power that genarted in AS genrator(the exitaion currnt or exitation voltge)
What is the maximum load of 240mmsequre single core cable can carry?
where do we connect tap of tap changer, to H.V. side or L.V.side? and why?
What is auto transformer?
28 Answers ABC, Transformers and Electricals, US Consulate,
if dc excitation is used to produce manetic flux in rotating machines then ehy it is not used in transformers.
SUPPOSE A CIRCUIT BREAKER HAS TRIPPED THE THE LINE WHEN A FAULT OCCUR ON IT.NOW WHEN THE FAULT HAS BEEN CLEARED, HOW THE CIRCUIT BREAKER WILL CLOSE AUTOMATICALLY NOT MANUALLY.
6 Answers Bureau of Energy Efficiency, DVC,
HOW WE KNOW IN PHYSICALLY THE CONTACT SURFACE OF A VACUUM INTERRUPTER IS GOOD OR GOING TO DAMAGE IN A VCB AFTER ABOVE 500 TIMES OPERATED.
in three phase with neutral connection, what will happen,if the neutral is in open condition with single phase distribution panel ?
iam using DM 3251 voltmeter(1 percent accuracy)for 11KV system PT ratio is 11KV/110V.can anybody explain what is the max and min voltage deviation.