Answer / guest

1)Why would you want to connect the supply lines to the
output of an autotransformer?
2)The reversal of what you have chosen will happen. that is
if you had connected the higher than normal tapping of the
transformer with the supply than you will get a lower supply
at the input side.
3a)The 10amp fuse and MCB connected depends on how big is
your autotxformer.
3b)When you connect an MCB OR a fuse to a 3 phase
transformer and if one of the fuses or MCB breaks than single
phasing happens in the circuit which is not good.If you must
protect use a three pole reliable MCB only.

why transformers are put with supply for 24 hours before giving supplying to a locality?

2 Answers  

---

Please tell me what is the difference between online UPS & OFF line UPS?

2 Answers   HAL,

---

to hook up ten 50 amp rv pedastels at a lenth of 600 feet from the service what size will my service need to be and the size of wire will I have to run to each pedastel in series??????

0 Answers  

---

what is the function of turbo charger in disel generators

1 Answers   Kirloskar,

---

my bachelors was done with EEE now i got admit in NU with CS as course. how to answer this qns 1) why u choose cs? 2) why u changed from eee to cs

0 Answers  

---

what is the need of capacitor in transmission lines?and how it works.

2 Answers   SCCL,

---

explain how to protect high rise building from the risk of lighting.

1 Answers  

---

What shall be the secondary output voltage if the primary winding of a 220/6V, 50 Hz transformer is energized by an 110V, 60 Hz supply?

0 Answers   HPCL,

---

What is the formula to calculate the size of Aluminium and copper cable?

0 Answers  

---

what is the difference between CT and CVT in EHV Sub Stations

4 Answers   Hofincons, Lanco, TATA,

---

what is different between DIGITAL and ANALOG?

3 Answers  

---

How much difference can there be between HT & LT KWH unit consumption at the same load?

1 Answers   DLF,

---