What is the difference between CRNO and CRGO in an
transformer and what is the advantages of these two.
Answers were Sorted based on User's Feedback
Answer / sunil ulange
CRGO - Cold Rolled Grain Oriented is the material used for
Transformer Windings.
CRNO - Cold Rolled Natural Oriented is the material Used for
Low quality Transformer winding constructions.
Is This Answer Correct ? | 19 Yes | 41 No |
Answer / vinothbabu.k
the material cold rolled grain oriented is used in
transformer core,its the aluminium material...advantages is
minimise the iron losses,as well as minimize the eddy
current losses...
Is This Answer Correct ? | 24 Yes | 51 No |
what happens in the short circuited secondary transformer,if the resistance of the short circuit is increased gradually?
some times voltage does not built in small generators why ?
What is the advantage of AC supply?
WHAT IS DEAD END IN PROTECTION?
WHAT IS THE FUNCTION OF PULSE TRANSFORMER IN DC DRIVE
Consider three heater bank connected in 3 phase star with neutral.Each heater bank connected in each phase.So each phase get 230 volts supply.my question is,during balance condition, current flow in neutral or Not
1.25 kg of hydrogen are burnt with stiochiometric air, the mass of air in kg required is
What are the main significances of root locus?
What is the full form of PSD & CSD ?
6 Answers NIFT, PNG Power, PSD,
what is the advantages og idmt relay over magnetic relay??
1- XC and the RC time constant are both measures of the reaction of C to a change in ____? 2-The power factor is a numerical ratio with a value between 0 and 1 equal to the ______________ of the phase angle. 3-When V and I are out of phase because of reactance, the product of V times I is called ______________ power 4-For _____________ inductors, the branch currents can be added algebraically. 5- The ______________ power in watts can be calculated as I^2R 6-Calculate XL with L = 30mH and f = 1kHz ( I have Xl=2piFL 2*3.141592653*1kHz*30mH =188 ohms Please check) 7-A parallel RL circuit has the values, R = 5kohms, XL = 5kohms. A voltage source of Vt = 10Vrms is connected in parallel to R and L. Determine the total current, It delivered by the voltage source Vt. 8-A series RC circuit has R = 1Mohm and C = 1microF. How long would it take for the capacitor to fully discharge if it is initially fully charged? 9-A circuit has real power = 300W and an apparent power of 500VA. Determine the power factor and phase angle. 10-The time constant for an LR series circuit is T = 0.1s and R = 10ohms. Calculate the inductance L.
What should the transformer connection of a 11/220 kV step up and 66/11 kV step down transformer ?