we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.

3 Answers  

---

What is the actual calculation for transformer short circuit test?.

0 Answers  

---

please send the last 5 years {{{JUNIOR ENGINEER - ELECTICAL, ELECTRONICS RRB CHENNAI and secundrabad}}} TECHNICAL question papers TO MY EMAIL ID dinesh100701@gmail.com

0 Answers  

---

Whats the diference between Induction motor and servo motor

3 Answers   Essar, PMT Machines,

---

On what basis the the size of Lightning arrester for buildings are selected ?

0 Answers   KGD,

---

Is it reuired to use house service barcket for 31/2 core 300 Sq.mm cable,if the distance between pole & shop is around 2 mtrs only or can I hang the cable with GI support in air? upto what size of cable GI serrvice btacket is necessary?

1 Answers   HAL,

---

why transmission lines traveled in high voltage?

5 Answers   TATA,

---

difference between servo motor and synchronous motor

0 Answers   Hitachi,

---

if two transformers are parallel & both have fault short ckt. impedance of 50KA in each case will it increase or decrease show example?

1 Answers  

---

how much power consumed by 1.5 ton capacity split A.C in 1 hour

2 Answers  

---

In secondary transmission i.e., in distribution side, supply for homes are connected through different phases in order to balance the 3 phase load. But in practical we saw nearby house doesn't have power due to single phasing. But other two phases give supply. How it's possible? it doesn't make "single phasing"?

1 Answers  

---

Three set (each phase contain 2 cable of 400 mmsq CU XLPE AWA) of single core cables are connected to 11 KV motor of 14 MW & the switch gear supplay is taken from 11kv feeder & this supplay taken from 275 KV substation. Problem is one pair cable(L3- 2 cable ) getting very hot & gland melted and damaged in switch gear side. the other two cable haven't any more hot(ambient temp only & L3 haveing 95- 100 Degree C. The same problem happened in 275 KV substation switch gear side also where the supply taken for 11 kv switch gear. But here L2 phese cable had problem. Why it is happening like this?. The cable having temperature different at different location from gland side inthe case of 11KV feeder of 275 kv substation. why ?

2 Answers  

---