Answer / reet

plz send me too i u get the question

Answer / guest

me same problem sir if u got regarding ths plz forward 2 my
mail nani_5579@yahoo.co.in

Answer / chetanya sahu

sir i'll be obliged if u can send me the interview questions
for instrumentation branch sooner as i have an interview on
22 april..
thanx
chetan.jss@gmail.com

A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.

0 Answers   MNC,

---

If Solenoidal valve works in manual mode but not in Auto mode. What should be the problem?

8 Answers   Bharathi Cement, Titanium,

---

in pressure gauge inside why we are using the glasarin oil?

4 Answers  

---

what is thermo coupler and how it works

2 Answers   Tisco,

---

which flow meter is use for measuring the open channel flow?

2 Answers  

---

what is solenoid valve?

1 Answers  

---

WHAT IS MEANT BY SUPERVISORY CONTROL?

3 Answers  

---

why is honed type flow orifice plate? what purpose it used? how to select this?

4 Answers  

---

What is the function of positioner in control valves? does the control valve operate without positioner?

3 Answers   Hofincons,

---

What is the Relation Between flow and pressure. How both terms related with each other.

1 Answers  

---

what is the current pay package for an instrumentation engineer having 2 years of experience in cryogenic technology???????

1 Answers  

---

why the positioner output is 3-15psi

5 Answers  

---