Answer / Ajay Pratap Singh Yadav

To calibrate an Interface Level Troll in the field, follow these steps:
1. Ensure that the process is shut down and the device is safe to work on.
2. Refer to the manufacturer's instructions for specific procedures.
3. Connect the device to a known level of interface liquid.
4. Adjust the settings according to the manufacturer's guidelines until the correct reading is obtained.
5. Repeat the process multiple times to ensure accuracy.
6. Once calibration is complete, document the results and compare them with the manufacturer's specifications.

while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?

1 Answers   Gasco,

---

I m appointed as an automation trainee engineer in small firm in that I am only the one , my company give me a project on s7-200 as i m beginner I don't know how to program so please send me the helpful site so that I complete my project before deadline....please help me out in this critical situation.

1 Answers  

---

why 4-20 mA in covection system?

3 Answers  

---

In bimetallic temp. Gauges why does metal strip bend? Why do we use low expansion factor metal and high expansion factor metal in bimetaliv strip?

1 Answers   Process Control Technologies,

---

Qatar fertilizer call me for interview as Instrumentation Project Engineer. Please let me know what kind of question they asked ? ALso they said they will take Written test, any idea about this written test ?

1 Answers   QAFCO,

---

What is transmitter

2 Answers   GNFC, QNFS,

---

How much should be the values and/or percentages of these given below factors for a good controller ? Steady state error Delay Rise Time Overshoot Peak Time Settling Time Damping Oscillations & vibrations thanks

1 Answers  

---

EXPLAIN NETWORK COMMUNICATION ON DCS?

0 Answers  

---

How do you identify an orifice in the pipeline?

1 Answers  

---

key phaser where is use and work

1 Answers   BAP,

---

 why Fahrenheit unit of moistur analyzer transmitter

1 Answers   Infosys, Samsung,

---

which transister (npn or pnp) is used in vibration monitoring for negative voltage? 

2 Answers  

---