Answer / 19911234

Transmitter transmit the signal to control room

Answer / vaghela narendra

Stem turbine generator 2pole how dose find out rpm

What is the minmum distance between the electrical panel and Instrument panel

1 Answers   Dodsal,

---

what is full form of NAK?

1 Answers  

---

Why 4mA-20mA current loop selected as standard ???

1 Answers   IMCO, Reliance,

---

I wnat to practice more online type questions .so will you show them me to take a practice test?

0 Answers   VA Tech Wabag,

---

why do we use 4-20 ma current why cant o-20ma

6 Answers   Southwest Cheese,

---

---

We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.

0 Answers   OPaL,

---

What are the key features of a Distributed Control System? describing the various layers (sensor through to business system interfaces) as well as the hardware, software and security aspects of the DCS.

0 Answers  

---

Manipulation of dead wt. tester double piston type.

0 Answers   CCIE,

---

What is megering????

2 Answers  

---

i want to find out iffco get test paper

2 Answers   IFFCO,

---

diff between neutral ,ground,phase , earthing and shielding?

0 Answers   L&T,

---

how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?

0 Answers  

---