explain call flow in gsm???

2 Answers   Nokia Solutions and Networks, TCS,

---

What is the state if the RED LED is glowing on PWSx card What is the state if the YELLOW LED is glowing on PWSx card

0 Answers   NSN,

---

Explain why normally control terminal of 555 timer is connected to ground through a 0.01µf bypass capacitor?

0 Answers  

---

What do you mean by ASCII, EBCDIC?

11 Answers  

---

interface an 8-pin switch with 8085 microprocessor located at 0AAH and LEDs at port 55H, draw the circuit diagram. Write down a program to read the switches and do the following: > if the parity of the switch is odd, start counting upward until it reaches 0FFH. > if the parity of the switch is even, start counting downwards until it reaches 00H.

0 Answers  

---

is Motorola GSM Duplexer active or passive device?

0 Answers   Motorola,

---

i have a problem in programming using string program is- rajasthan rajasthan rajastha ajasthan rajasth jasthan rajast asthan rajas sthan raja than raj han ra an r n plz reply soon as posible as

0 Answers  

---

what is the minimum and maximam trace width in PCB design? why trace is measured in mils? what is the use of via? why the crystal oscillator is placed near chip?

0 Answers   Wipro,

---

what is the reason of RDI alarm in microwave link?

0 Answers   TATA,

---

i want computer associates placement papers from u? pls post to me.

0 Answers   BSNL, CA,

---

What is eddy current?

5 Answers   CTS,

---

What are d uses of a diode . What is diode equation . And what is its use

2 Answers   Bosch, Infosys, Siemens,

---