Interested to Buy Any Domain ? << Click Here >> for more details...
capacitor is load free component but why ampare meter shows
current when capacitor bank breaker close?
- 5 Answers
- 15222 Views
- Bhel, OPS, I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / abdurrahim
As we know that Electrical is having two type of load,
Active and Reactive.Capacitor is a reactive load,Which is
not considering as a load,& its factor is Isin@.Meter is
design based on Current RMS value.Because of it, Meter is
showing the current RMS value.
| Is This Answer Correct ? | 16 Yes | 1 No |
Answer / samar
the capacitor bank takes a current to charging thier
plates .the ampare meter shoing this current & also there
are some dielectric loss
| Is This Answer Correct ? | 6 Yes | 4 No |
Answer / rama krishna
capacitor is a leading kvar generator.name plate of the
capacitor bank gives the current details also.it is not
taking the load(amps) from the mains and it is giving
reactive load to the mains.that load shows in am meter.
| Is This Answer Correct ? | 6 Yes | 5 No |
Answer / ayush purwar
Because it stores energy in it.
After an external current is removed..
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / shrikant muthineni
If i am not wrong than what rama wants to convey is that as
capaitor is a KVAR generator the ampere shown in the
ammeter is the load actual consumped more by the sys if
the capacitor bank is not there,please correct if i am
wrong.
| Is This Answer Correct ? | 1 Yes | 2 No |
How to calculate the cable size for particular load
what are check points to be checked while charging switchyard?(CT,PT,BREAKER,POWER TRANSFORMER)
why cant we use earth as neutral at home whereas neutral is actually grounded at transformer end?
According to general circuit diagram of 1-Phase t/f , why the primary is not get short circuited ,even though the supply terminals both are directly connected through primary winding?
Why we call cable rating in SQ.mm.If it is 240 SQ.mm how much the diameter possible?is there any calculation ?
How to calculate incoming cable size for 33KV, 1MVA transformer.
What is the most important precaution in any experiment with d.c. Shunt motor?
what is the resistance value of earthing pit and why they are connected?
how to difference between the HT< cables
What are electric motors?
dear all, in motor operation , motor is of 100 hp and bimetal relay setting is 130 amp, if relay is getting tripped on 120 amp balance current what can be the reason? Relay is newly replaced. I dont know but is there any frequency effect in thit case? Can frequency variation affect bimetal relay operation?
What are the three major categories of error?
-
Civil Engineering (5086) - Mechanical Engineering (4456)
- Electrical Engineering (16639)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
