What are the major reasons for balancing hydro-thermal mix?
No Answer is Posted For this Question
Be the First to Post Answer
what is the wattage of 'zero watt' bulb?
What is the different between conventional MCC and intelligent MCC? Common controller or controller for each bucket
I want to ask a question which i faced during testing of Capacitive Voltage Transformer in AIS. We have measured the C1 , C2 individually , but when we start to measure the total C1+C2 , the testing equipment shuts down and says low loading. Kindly is it possible to find the total capacitance by using measuring device. kindly briefly explain the procedure.
what is the purpose of fuse?
how could we know the size of cable by physical view?
0 Answers Havells, United Engineering,
why does the magnetic balance tests at transformer?
Is it necessary to install Lighting Arrester on both side side (i.e HT and LT) of Transformer in a transmission substation? if yes Why on both side?
a room heater is connected in serise with a 100w bulb.if the 100w bulb is replaced by a 40w bulb then the output of the heater is increase/decrease/remain same?
9 Answers College School Exams Tests,
What is kvar?
why the check zone and main zone are used for Busbar Protn. scheem?
What is the transformenr turns ratio.
why hv current transformers have big size ?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)