Specify the crystal frequency required for an 8085 system to operate at 1.1MHz

1 Answers  

---

WE HAVE THE DC RECTIFIER 1500A, INPUT VOLTAGE IS 3 PHASE. HOW TO CALICULATE THE LOAD? 3 PHASE SIDE EITHER dC SIDE. PLEASE SUGGEST ME

0 Answers  

---

What is main purpose of chock coil and starter in florescent tube ?

1 Answers  

---

In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes

0 Answers  

---

Is there any design in the world a 220 KV transformer without breather …??????

2 Answers  

---

WHY DOES NEUTRAL DO NOT CARRY EVEN THOUGH IT CARRIES RETURN CURRENT?

3 Answers  

---

9.The material used for coating the electrode is called........

3 Answers   SSC, TELiBrahma,

---

what r the preventive maintenance of air compressor

1 Answers   Jindal,

---

difference between relay and solenoid?

2 Answers  

---

In single phase ac ups supply when current is measured with tong tester neutral current is found more than phase current.What is the reason?

0 Answers  

---

what is the difference between inductive load and capacitive load?give me some examples in general

3 Answers  

---

What type of wiring series or parallel is used for conventional and addressable type FAS & why?

0 Answers  

---