Answer / Divyanshu Rai

Cold drawing is a metalworking process used to reduce the cross-sectional area of a solid piece of metal. The following are some common cold drawing processes:
1. Straight Drawing: This involves pulling the workpiece through a die opening with a constant draw ratio.
2. Taper Drawing: In this process, the workpiece is drawn into a die opening that tapers in the direction of the drawing motion, resulting in a tapered part.
3. Cross Drawing: This process involves drawing the workpiece across the die opening, perpendicular to the direction of the drawing motion.
4. Redrawing: This process is repeated multiple times on the same workpiece to further reduce its cross-sectional area.

What are all the possibilities discharge will be low in the pumps?

12 Answers   JSW,

---

how to control ovality in internal diameter

1 Answers  

---

• Why only 3 phase?

1 Answers   NTPC,

---

What is a uniformly distributed load?

1 Answers  

---

What do you going to observe, when a diesel engine is running?

1 Answers   CSI,

---

Define a positive displacement pump?

1 Answers  

---

Is OHNS steel is equivalent to O1 tool steel? Suppliers give OHNS material for AISI O1 STEEL telling that both are equivalent materials. Is this correct?

1 Answers   PH.D Interview,

---

hi this is swaroop i appliled for masters in us for mba and my ielts score is 5.5 and no gre and i have 14 backlogs

1 Answers  

---

what is the difference between shaft vibration and bearing vibration?

1 Answers  

---

My interview is on 21/09/07.Kindly send me the Questions and answers on 1)Inspection and testing of pumps & compressor, 2)Piping 3) HVAC

2 Answers  

---

boiler fusible plug melt down, normally melt down due less water or feed pump failure, but is there any possibility of fusible plug melt down due to high temperature in firing zone and at that time water level is perfect at it's level.

1 Answers  

---

How does a boat measure speed?

1 Answers  

---