Can a transformer designed for a particular voltage and frequency rating be used for different set of mentioned ratings? Assume that the winding does not get burnt because of overheating at higher voltage. If yes, then under which constraint it is possible?

1 Answers  

---

For the requirement of a furnace of temperature range up to 1200 oC using silicon carbide rods, What is the required rate of transformer needed (please do it with all details)?

0 Answers   Intel,

---

Why mostly the HV side of transformer has Delta?

0 Answers  

---

3 ph motor connected in star delta starter. when we start the motor it run in star but when in is going in delta it trips the main incoming supply. why?

3 Answers   Bajaj Hindusthan,

---

How to calculate energy stored in a capacitance

0 Answers  

---

which motor have relatively high power factor and what is reason for have high pf? 1.capacitor run motor 2.shaded pole motor 3.capacitor start motor 4.split phase motor

0 Answers  

---

what we happen if 400 kvar cpacitor banks are on in manual mode and there is no load on mains ??????????????

7 Answers   HCL, Reliance,

---

why does the time taken for fuse to melt is longer as the wire length increases?

1 Answers  

---

what is the formula for 3 phase motor starting cureent deatials 3phase 148A delta 415v, efficiancy 94% can we run the motor with 200A incoming supply

2 Answers  

---

6.6 KV /.415KV Step down trf. we can get 6.6 KV from primary by applying .415 KV secondary side by same TRF.

3 Answers   Suzlon,

---

What are the application of Under voltage release?

2 Answers   Techno Electric and Engineering,

---

In a company has been installed an analog amperemeter, this company was suplied by generator X, there is no problem in the ampere meter, rigth now this company's supplied by generator Y then the pointer in amperemeter vibrating. What happened? Why? Thank's

2 Answers  

---