is petroleum a mixture of hydrocarbon?

5 Answers  

---

all subject of chemical engg

1 Answers  

---

what is the role of a chemical engineer on a cement plant?

4 Answers  

---

What is higher heating value and lower heating value? Is it positive or negative?

0 Answers  

---

NATURAL GAS ENGINEERING - QUESTION 26.2 : (a) The Hyperion sewage plant in Los Angeles burns 8 million cubic feet of natural gas per day to generate power in United States of America. If 1 metre = 3.28084 feet, then how many cubic metres of such gas is burnt per hour? (b) A reservoir of natural gas produces 50 mole % methane and 50 mole % ethane. At zero degree Celsius and one atmosphere, the density of methane gas is 0.716 g / L and the density of ethane gas is 1.3562 mg / (cubic cm). The molar mass of methane is 16.04 g / mol and molar mass of ethane is 30.07 g / mol. (i) Find the mass % of methane and ethane in the natural gas. (ii) Find the average density of the natural gas mixture in the reservoir at zero degree Celsius and one atmosphere, by assuming that the gases are ideal where final volume of the gas mixture is the sum of volume of the individual gases at constant temperature and pressure. (iii) Find the average density of the natural gas mixture in the reservoir at zero degree Celsius and one atmosphere, by assuming that the final mass of the gas mixture is the sum of mass of the individual gases. Assume the gases are ideal where mole % = volume % at constant pressure and temperature.

1 Answers  

---

When should one be concerned with the tube wall temperature on the cooling waterside of a shell and tube exchanger?

0 Answers  

---

Question 66 – The drag coefficient Cd = 0.05 and lift coefficient Cl = 0.4 for a levelled flow aircraft are measured. The velocity of the aircraft is v = 150 ft / s with its weight W = 2677.5 pound-force. (a) Find the value of the lift of the aircraft, L, when it is also its weight. (b) The drag of the aircraft, D = Cd M, L = Cl M. Find the value of D. (c) The power required is P = Dv. If 1 pound-force x (ft / s) = 1.356 W, find the value of P in the unit of Watt or W.

1 Answers  

---

Are there any general rules for flushing slurry lines?

0 Answers  

---

How to calculate the sonic velocity of a gas stream?

1 Answers   Sony,

---

pleas tell me about chemical engineering apptitude test..

0 Answers   IOCL,

---

How can you control the ph level in our cooling water with respect to ammonia contamination?

0 Answers  

---

PLZ ANYONE SEND ME PLACEMENT PAPERS OF I.O.C.L MY ID---- gaurav.nitw.5609@gmailcom

0 Answers   IOCL,

---