What is A check, B check, C Check & D check for a diesel Generator? Please guide me as this question was asked many times and till now i haven't get right answer.If you can mail me then please mail me the answer @ yogiagarwal@gmail.com.

20 Answers   Apollo Power, BDV, Bosch, Further Future, Honda, HVCC, Jackson, Kirloskar, Multi Arc, Ranbaxy, Regulus IMC, TVS, XCD, YWS,

---

how to calculate volume of torispherical head in design of pressure vessel???????

3 Answers  

---

what is Production Planning&schedule?

1 Answers   L&T,

---

RRB exam model questions pls forward.

0 Answers   RRB,

---

State newton's three laws of motion.

0 Answers  

---

1: t-s dig. of gas turbine and efficiency[with reason]? 2: t-s dig. of compressure and efficiency[with reason]?

3 Answers  

---

meaning of 125kva DG

0 Answers  

---

2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand

0 Answers  

---

Company insists on a joining bond to protect the investment made in recruiting, training and mentoring employees. Are you willing to make this commitment ? -1 year for candidates > 5 years experience -2 years for candidates with 2-5 years experience -3 years for candidates with 0-2 years experience

0 Answers  

---

why we use kg/cm2 in pressure gauge not kg/m2

0 Answers  

---

What is the congressional space medal of honor?

0 Answers  

---

can i see mahagenco exam model question paper?

0 Answers   MahaGenco, TATA,

---