Single reduction is used in final drive when it is about a) 6:1 b) 8:1 c) 10:1 d) 12:1

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

What happens if gasoline is used in a Diesel engine?

0 Answers   GM General Motors,

---

What is an injector pressure in heavy vehicles?

0 Answers  

---

State some of kingpin offset application.

0 Answers  

---

High speed gear is obtained in the case of sliding mesh gear box when a) Motion is transferred through the clutch gear to lay shaft gear b) Main shaft is coupled to the clutch shaft c) Smallest gear on the lay shaft is engaged d) Largest gear on the lay shaft is engaged

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

The maximum amount of axial load to be applied on a clutch plate is a) 100 KN b) 200 KN c) 300 KN d) 400 KN

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

What is the range of engine efficiency in case of two stroke engine?

0 Answers  

---

What direction of rotation in crank? why not it rotate opposite direction?

1 Answers  

---

Slip joints are provided in the propeller shaft a) To adjust the inclination of the propeller shaft b) To adjust the length of the propeller shaft c) To prevent the whirling of the propeller shaft d) To adjust the up and down movement of the rear axle

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

During the drive torque, what will be the weight shift?

0 Answers  

---

Discuss the Otto cycle.

0 Answers   Ashok Leyland,

---

The land rover 110 defender stop because someone put water/kerosene in a fuel system,what can I do in order the to run again...

1 Answers  

---