The land rover 110 defender stop because someone put water/kerosene in a fuel system,what can I do in order the to run again...
Answer / brian ski
The fuel tank would have to be completely emptied and cleaned. It would help to flush or drain the fuel lines, and change the fuel filter. If the vehicle has a carburetor it should be taken apart and cleaned of bad fuel. If it is fuel injected you may be able to run it on starting fluid until the injectors are purged of bad fuel.
Is This Answer Correct ? | 2 Yes | 0 No |
Why not cars which have a wheel type steering, requiring many rotations to be made to turn the car, be replaced with a handle type steering, like the one provided in a autorick shaw for quicker turn?
If the given tractive effort curve and the total resistance curve does not intersect, then a) The vehicle will accelerate b) The vehicle will decelerate c) The vehicle will not be able to go at this gradient for the given gear d) None of the above
0 Answers Backbone, Bosch, MAHINDRA, Uniparts Group,
What is the difference between BS2
The permanent reduction provided by the final drive in heavy vehicle is a) 4:1 b) 6:1 c) 8:1 d) 10:1
0 Answers Backbone, Bosch, MAHINDRA, Uniparts Group,
Explain different between two stroke engine four stroke engine?
What are the troubles in inaccurate gauge reading?
How power can be generated in engine?
how does the engine starts working when we start our twowheeler
For the second gear in a synchromesh system, the drive transfer will be through a) U1, U2, C, F2, and splines b) U1, U2, C, F1, and splines c) U1, U3, D, F3, and splines d) U1, U4, U5, E, F2, and splines
0 Answers Backbone, Bosch, MAHINDRA, Uniparts Group,
What is the difference between SPC & SQC?
High speed gear is obtained in the case of sliding mesh gear box when a) Motion is transferred through the clutch gear to lay shaft gear b) Main shaft is coupled to the clutch shaft c) Smallest gear on the lay shaft is engaged d) Largest gear on the lay shaft is engaged
0 Answers Backbone, Bosch, MAHINDRA, Uniparts Group,
What is the function of flux in welding?