Answer / nknehru

Lap length is the length of the overlap of bar required to safely transfer stress from one bar. The lap length may vary based on the dia. of the rebar and design. In general for Columns 56 D, Beam & Slabs 50D we are giving during construction.

Answer / sribalu

slab=50d, beam= bottom=40d, top=24d

what is w/c ratio in dry lean concrete for m10 mix design

0 Answers  

---

what is the grade of lean concrete?

3 Answers  

---

In footing (mat) if two different dia of rods are to be used which rod should be placed at top and bottom ( eg. 10mm & 16mm dia rods)

7 Answers  

---

Explain how you can use different dimension tools in CAD? What are the different dimensions available?

0 Answers  

---

Gave a cantilever beam with 3 legs.Told to draw the bending moment diagrams, axial force diagrams and shear force diagrams.From BMD he asked to show how the reinforcement will be provided on the tension side.

0 Answers   L&T,

---

In foundation design, while we do the base pressure check, we normally check if the attained pressure value is less than the GROSS BEARING CAPACITY of the soil which is the sum of net bearing capacity of soil and the overburden pressure. Actually, the overburden pressure acts against the net bearing capacity of the soil and I feel that we are actually increasing the bearing capacity value and doing the check. I feel that this is NOT right. Please clarify on this.

0 Answers  

---

Journal entry Gross salary 10000 Tax 1000 Employee contribution 2000 Employer contribution 2000

0 Answers   Accurate Engineers,

---

What is the diffence between prescribed mix and design mix

3 Answers   DPI, L&T,

---

structural engineering based

4 Answers   HPCL, L&T,

---

. What three Specific Job Positions do you target from the Company

1 Answers   Hilton,

---

suppose we have a tendency to make a hole on the surface of the beam, than where we goes to make it?

3 Answers  

---

what is meant by VDF FLOORING? why it is used?

3 Answers  

---