why is M25 and Fe 500 assumed to be most economical? i feel it is not.This is because higher grade of concrete and steel has higher lapping length and anchorage length compared to lower grades..
No Answer is Posted For this Question
Be the First to Post Answer
if the nitrates more than 45mg/l in water lead to disease then what is it called
i have to give lap joint fo 1Mtr steel of dia12mm,whenever i did mistake i cut less 5cm plz tell me how much i will give lap joint so that length comes 1Mtr
0 Answers National Construction Authority,
Totally how many Grades of Concrete are there? and Explain Briefly?
A floor has to be removed partially with block work tying floors together, can block work continue on floor that has to removed excluding demolishing works tying floor from underside of slab and top of slab demolishing floor upon completion?
Dear Sir I Mahesh C. Bhamre have already given a Exam for Superintendent Officer / Public relation Officer Exam Dharmday Aaukta held at Nashik on Date 29/08/2010. My seat no was 5040247. and my cell no is 9822677994. and my mail Id is - mahesh.bhamre@rediffmail.com So can you pl send me details of result of respective exams. Thanking you in Anticipation.
What is value of S.F at Point of contaflexure?
what is the water cement ratio for plastering
what is the advantage of electronic theodolite over transit theodolite?
Why we use sin wave only in ac not use any other form of wave?
which is greater moment at centre or fixed end moment for a fixed beam with udl
what is the code provision for acceptance of fineness modulus range for fine aggregates in design mix
What is difference between code and standard and specification?