Answer / powerplant.calculations

Control oil is used for
1-Governor to operate the valves as per load requirement
2-To operate ESV

Refer below link for more information
https://www.powerplantandcalculations.com/2020/06/steam-turbine-practical-questions.html

what is natural frequency of turbine shaft .

1 Answers   Thermax,

---

can dp type level transmitter work in under vaccum condition

1 Answers  

---

why the Steam Turbine(20MW)center line and gear box center line not in same elevation during coupling alignment ?

3 Answers   Greenesol Power Systems,

---

line safety is not opening but drum safety opens what to do?

3 Answers  

---

What is surging in a centrifugal compressor ? How it occur's ? How is antisurging done ?

1 Answers   RasGas,

---

what is CT saturate?and which effect on CT after its saturate?

4 Answers  

---

63.5 ohm NGR is connected with our gas engine genrator running at 500 rpm, 50 hz and synched with WAPDA at 6.3 KV bus voltages, 2500A and 25KA(1 sec). can some one give me proper calculations how it comes 63.5ohm?????

2 Answers   UET,

---

I want to build 100 megawatt hydel dam. What does mean, 100 MW per hour? then how many electric bulb of 100 Watts the dam would lit?

1 Answers  

---

What is wheel chamber in steam turbine?is it impulse blades are called wheel chamber in the steam turbine?

1 Answers  

---

dear sir i have completed one year post diploma certificate in thermal power engineering from national power training institute durgapur ...plz suggest me for power sector job

1 Answers   dbpl,

---

What will happen if id fan on boiler not functioning?.Can the Boiler run without id fan? What is the effect?

4 Answers  

---

A 5A rewirable fuse blows when 9A flows.determine the fusing factor?

1 Answers   Schneider, Student, Tata Power,

---