I have a question, I visit 01 site and face a problem, there is 2.5 ton Air Con working, when air con compressor is running at that time rectifier voltages are increasing upto 290-295 v and rectifier is giving main high alarm (rectifier is APC single phase, before starting compressor rectifier voltages was 230v. when air con is going off rectifier voltages are decreasing smoothly at its actual voltages 230v. Load on Genset phases is this: Red-13.5 amp AC (Air Con load), Yellow-1.7 amp AC (BTS lights etc.) and Blew-4 amp AC (telecom system load), Genset phase to phase and neutral to phase voltages are also ok. These are 10 sites having same system and same rectifier APC brand at every site 02 genset are working but the problem is same at all these 10 sites. What will be the reason behind???

1 Answers  

---

What is the difference bet ween EDO Type & MDO type ACBs, and what is the advantage EDO Type over than MDO type ACBs.

2 Answers   Siemens,

---

Define motor & pump?

3 Answers  

---

what are the main problems that happen in an emergency light and how to fix them ?

2 Answers  

---

what is mean by parallel operation of permanent magnet generators

0 Answers   PSD,

---

what is the multi strand cable size? 0.45mm is area of one strand & 370nos of strand.

1 Answers  

---

How to increase solar cell efficiency ?

1 Answers  

---

Define what is difference between fuse and breaker?

0 Answers  

---

what questions will be asked for 11/33KV licence interview APSEB hyderabad. Can any one share question and answers.

0 Answers  

---

what is dc mator?types of dc motor?losses in dc motor?what is the mechanical,electrical and commercial efficiency of a dc motor?

0 Answers  

---

HOW TO CALCULATE LV CABLE SIZING?

2 Answers   L&T, MRF,

---

How to calculate battery back up time for a 400 AH battery bank installed in telecom shelter for a load of 20 Amps and time taken to fully charge this battery bank?

3 Answers  

---