steel which is used for reinforcement and structures why they are directly used

steel which is used for reinforcement and structures why they are directly used why GALVANISATION or PRIMER is not done to prevent from corrosion

Question Posted / yash rana

steel which is used for reinforcement and structures why they are directly used why GALVANISATION or..

Answer / manish kr

Due to priming or galvenising steel doesn't make perfect bond with concrete so we avoid this

Is This Answer Correct ?

5 Yes

0 No

More Civil Engineering Interview Questions

what is the compressive strength of concrete cube of ratio 1:6:12?

in a mix if desired concrete slump is not obtained , the adjustment of each concrete slump difference is made by adjusting water by which percentage

pls tell estimate for 1 kilometre length random rubble masonry 0.90 metre height 0.600 metre width

How to ascertain the required grade of Steel is good for Site .....

how much cost of single coat 20mm thick plastering per sqre meter

What is the force exerted by the tacoma narrows bridge?

Typical floor design load in Residential Building----------- -----

what is the difference between built-up area & carpet area? how to calculate this areas?as there are any formula to calculate these areas?

How to check the quality of fine aggregate on site?

What was asked in isro civil interview

what is that one cub metre plaster in cemant and fine sand

In which grade of steel the laping length required is more,Fe 415 or Fe 500 ? and why?

For more Civil Engineering Interview Questions Click Here