Answer / uvaranjini

When the speed of the motor reaches about 70% of its synchronous speed, the starting winding will be disconnected by means of centrifugal switch (CS).

Answer / uditparashar

centrifugal switch is used for diconnecting the starting winding from the motor once it reaches the normal operating speed.

Answer / suresh

Centrifugal switch is used for when the motor speed reaches 75% then starting winding disconnecting from circuit.it is only starting purpose only.

What is short circuit analysis of electrical networks?What are the procedures to be followed for its calculation?

2 Answers   DLF,

---

What is Transformer?

23 Answers   HSL,

---

In a poly phase circuit if clamp on meter shows same load on three phases and their sum on neutral then why we use three and a half core cable or maximum the same size of core as that of phase?

1 Answers  

---

why can't we increase the voltage by increasing the field voltage in order to get higher voltage.so that we can eliminate step up transformer

4 Answers   Bhel,

---

MCB is used for high rating &MCB is used for lower rating.What is technical difference between ACB & MCB?

7 Answers  

---

what happen when transformer connect on dc supply.

5 Answers  

---

wat is meant by PX class in ct?

1 Answers  

---

If i have 200 test cases and we have to execute but we don't have time to execute all testcases.within 1 hour we have to execute that testcases and prepare the test report.so how i have to resolve this problem? is there is any technique in the testing.

3 Answers   Stag Computers,

---

Why i receive the GCU fault in my DG Sychronization panel . what all the factors considered for this fault .

1 Answers  

---

Advantage of LT panel vs HT panel

1 Answers  

---

what is difference between fuse and circuit breaker?

4 Answers  

---

why the crow do not feel the current in overhead line when it sits on the wire??????

6 Answers  

---