Distribution transformer we provided 2 separate earthing pit for Body and 2 separate earthing pit for neutral,we can not connect separate body earthing pit to other earthing pit but we do metal glanding in secondary side cable termination in both side, transformer and PCC panel (LT Panel), is this safe for transformer and other equipment?
No Answer is Posted For this Question
Be the First to Post Answer
BRIEF ME CHECKING PRCEDURE OF BATTERY 12V 26AH
differentiate PLC,DCS,SCADA?
To avoid arcing what we connect in earthing.
Application wise, where we should use AC motors and where we should DC motors?
where this neutral connection goes after returning from the load(home ,factory,industries).Is it grounded at the transformer side or atthe generator side .If it is grounded then we also ground the earth connection.is there any problem with this.
what is parellel power factor correction?
can we calculate the diameter of the cable by its cross section?
In a house wiring why we are using only one neutral wire and so many phase wires from the main board, when the load is common for both wires?
WHERE IS THE LIGHTING ARRESTER SHOULD BE PLACED IN DISTRIBUTION LINES?
How many types of interlocking use in screw type air compressor,make-Kaser(BSD MODEL)?
0 Answers Automobile, Siddhi Vinayak,
Why computer humming sound occurred in ht transmission line?
What is dc induction motor ? and how to control its speed ?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)