why we are maintain the gap voltage in vibration probe when installing time can

why we are maintain the gap voltage in vibration probe when installing time can explain me?

Question Posted / sr

1 Answers
3991 Views
CIL, I also Faced
E-Mail Answers

why we are maintain the gap voltage in vibration probe when installing time can explain me?..

Answer / kumaran

The EDDY current generates between the vibration probe tip and the shaft area. Increasing and decreasing of the area by the shaft will make the measurement of vibrations. So it needs to be done during the installation.

Is This Answer Correct ?

3 Yes

0 No

Post New Answer

More Instrumentation Interview Questions

Why Differential pressure transmitter is located below the tappings points for steam & condensible vapor flow measurement application?

2 Answers

What is the basic difference between 2 Wire, 3 Wire and 4 Wire RTD

2 Answers

what is the difference between DELTA-V & FOUNDATION FIELD BUS

4 Answers

What is the difference between conductive lined pipe and conductive unlined pipe? Why do we see that?

0 Answers Process Control Technologies,

Why is a dead weight tester so called by that name?

1 Answers SGS,

What is instrumentation control?

0 Answers

1. what is 3 point calibration & 5 point calibration? 2. If we use hart communicator to set the LRV & URV of a smart transmitter, did we calibrate the transmitter? why? 3. Make a complet list if meterials needed to properly connect a pressure gauge to a steam pipe using 1/2 inch stainless steel tubing. The gauge connections is 1/2 inch NPT-M and the steam pipe tap has a 1/2 inch female coupling, compression fittings are use. 4. What are the tools in loop checking? 5. What would the ISA symbol of a square root extractor look like? 6. What would you do to completely prepare for the configuration? 7. What safety measures must you undertake when doing configuration? 8. what are the two most commonly use programming languages used when we configure a PLC? 9. What would you do if you accidentally skipped a step in the configuration procedure? 10. How would you know if the configuration were sucessful? 11. Name at least 3 selections available when we configure the burnout protection of a controller?

3 Answers EI Electrotechnical Institute,

Define cryogenic?

0 Answers

What is Erosion in a control valve?

0 Answers CCIE, Fisher,

describe yourself?

1 Answers TCS,

I need control valve ISA hand book. Is there any site to download that big book containing all the pages. Written by Paul Friedmann

0 Answers

what is the calibration procedure for magnetic flow meter @ onsite

0 Answers

For more Instrumentation Interview Questions Click Here