How to calculate mf when meter equipment and meter are connected



How to calculate mf when meter equipment and meter are connected..

Answer / Aradhana Mishra

The MF (Maximum Frequency) of a meter depends on the specific type of meter and the system it is connected to. Consult the manufacturer's specifications or guidelines for proper calculation methods.

Is This Answer Correct ?    0 Yes 0 No

Post New Answer

More Electrical Engineering Interview Questions

how to electrically make connection to ferroli GN2N?

1 Answers  


Why AC current leads voltage in capacitor and how?

1 Answers   BMB,


How to calculate motor current for 3 ph & 1 Ph motor from KW rating?

3 Answers  


Can we use Motor protection CB while we use the VFD for Speed control?? if not means please tell the reason!!!

1 Answers  


can we use 220 volt 15 w a.c. lamp on 220 volt d.c.

11 Answers   Philips,


what the effect will occur if we increase the airgap in induction motor

3 Answers   ONGC,


What is the purpose of SOTF being used inspite of distance Protection given?

7 Answers   Alstom,


What is the difference between MCB and Earth MCB? What is the working principal of MCB?

2 Answers  


What is the physical significance of phase.. i.e. what is exactly the meaning in layman's language.. 1 phase, 3 phase etc ???

1 Answers   L&T,


What are thermo couple cables and where they are used.

2 Answers  


when we have to purchase the transformer by own i.e how much load will preferred HT connection?

1 Answers   Power Square,


I BOUGHT A HAVELLS ACCL WITH GENERATOR STOP FASCILITY(i.e- BASICALLY IT IS A AUTO CHANGE OVER SWITCH) FOR MY HONDA EXK 2000S HOME GENERATOR (WHICH START IN PETROL & RUN IN KEROSENE). ACCL HAS 8 POINT. 2 FOR MAINS(PH & NUE), 2 FOR LOAD, 2 FOR GEN AND 2 FOR IGNITION POINT(X1 & X2). THE IGNITION POINT IS SPECIALLY FOR AUTO ENGINE STOP WHEN MAINS POWER RESTORE. I CONNECT THIS X1 & X2 POINT TO THE GENERATOR STATER MOTOR & EARTHING POINT. BUT WHEN MAINS FAILS THE GENERATOR COULD NOT START, BUT WHEN DISCONNECT THOSE X1 OR X2 POINT, THEN THE GENERATOR START. BUT WHEN MAINS ON THEN THE GENERATOR SHOULD START, AND WHEN I OFF THE MAINS THE GENERATOR AUTOMATICALLY STOP. PLESE HELP ME HOW I STOP THE GENERATOR AUTOMATICALLY WHEN THE MAINS RESTORE.

2 Answers   Honda,


Categories
  • Civil Engineering Interview Questions Civil Engineering (5086)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4453)
  • Electrical Engineering Interview Questions Electrical Engineering (16638)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)