For Bus duct hi pot test, where we want to connect the return and ground leads?

Question Posted / khan

2 Answers
4944 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

For Bus duct hi pot test, where we want to connect the return and ground leads?..

Answer / pramod nair

for bus-bar hv test we have connect first which phases you are appliying the voltage then you have to be grounded another two phase that means R-Y+B+E , You are appliying voltage in R phase means another phases you have to make it ground.

Is This Answer Correct ?

1 Yes

0 No

For Bus duct hi pot test, where we want to connect the return and ground leads?..

Answer / mohd fazil

the more specific Hot Hipot test can bring about feelings of apprehension. Yet the concepts involved ... peak (maximum) voltage is what we are concerned with. ... Connect the return lead of the Hipot tester to the metal chassis or enclosure of a ... transformer is used to isolate the input power to the DUT from earth ground.

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

why actual valve timing diagram is different than ideal valve timing digram of a 4 stroke engine?

0 Answers

How can make a star delta with Rstar delta feeder ( ( 4contactor & one timer ) pls answer with digram (power &control digram)

1 Answers

What is high frequency grounding????Applications........

1 Answers Emerson,

Draw the single line diagram of the power station?

0 Answers

What is the difference between ground and neutral ?

2 Answers TCS,

Is there any particular formula for sizing the bus bar based on the current rating

1 Answers Bunt Solar,

what is differance between dirty earthing and clean earthing and their applications

2 Answers CB&I Lummus,

We know that, in case if there is a faulty insulation,or sc, the current is bypassed to earth through the earth wire that has low resistance.Actually, what will happen to that current that flows through gnd?In that case,if we come in contact with that faulty appliance, wont that current flow through us as we form a closed path by standing in gnd?Is grounding a safety measure?

3 Answers

why designer use kva rating instead of kw in transformer rating???????????????

9 Answers

what is vector surge & vector shift? we have 25.3 MW(11kv) generator & 11kv/132kv transformer, connected with with 132 kv grid.vector surge relay is tripping frequentaly.what is permissible maximum limit for this.

3 Answers

what are the duty ratings in DG sets?

1 Answers L&T,

as a electrical student why should i hire you?

0 Answers TCS,

For more Electrical Engineering Interview Questions Click Here