Answer / waris jamal

one ton of refrigeration = 12,000 BTU/hr.

When it comes to relating this to air quantities, the basic equation is:

Q (btu/hr) = 1.08 (constant for air at standard conditions)*density correction factor*cfm*delta T

400 cfm per ton is a manufacturers nominal standard, or rule of thumb. It should get you in the ballpark, but is not exact.

What is the function of thermostat in cooling system of an engine ?

0 Answers  

---

How many types of oil spilling available?

0 Answers   L&T,

---

who was the frist rail ladies driver

2 Answers   RRB,

---

2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand

0 Answers  

---

How much calorific value of heat is needed to heat 00c of

0 Answers   ABC Inc, RRB, Siemens,

---

What is the use of metal jack plane?

0 Answers  

---

Name the safety devices of diesel engine?

0 Answers   RRB,

---

How cn u measure to steam in kg/hr or ton/hr

6 Answers   Samsung, Samtel,

---

what is differences between welding & brazing?

2 Answers  

---

How will you measure the eccentricity of the turbine rotor during running

0 Answers   Reliance,

---

What are the different types of gate valves?

0 Answers  

---

What is the developed on working company

1 Answers   Saint Gobain,

---