what are the types of welding tests please answer or e mail
to chethanbabu007@gmail.com
Answers were Sorted based on User's Feedback
Answer / kkumar
Various kinds of testings are available for welding
1. Visual test
2. Die penerternt test
3. Magnetic particle test
4. Xray test
5. Ultrasonic test
Is This Answer Correct ? | 23 Yes | 5 No |
Answer / nishant
2 types:-
Destructive and Non destructive.
which can be further classified as
ultrasonic,x-ray,penetration etc....
Is This Answer Correct ? | 9 Yes | 0 No |
Answer / i.senthilvanan
visual test
die penatrating test
x ray test
magnetic particles test
ultrosonic test
Is This Answer Correct ? | 8 Yes | 0 No |
Answer / arul
Apart from the above mentioned answers, for the BUTT WELDS
in the pipelines we commonly use HYDROTEST. it is used to
check whether the joint is capable of handling the liquid
at 1.5 times of the working pressure.
Is This Answer Correct ? | 8 Yes | 0 No |
Answer / harsha
Tensile test is done ia a UTM(universal testing machine)
to know the strength of a weld portion. this is also one
kind to the above listed.
Is This Answer Correct ? | 10 Yes | 5 No |
Answer / maunish shah
VISUAL TEST
DIE PENETRATION TEST
X-RAY TEST
ULTRASONIC TEST
MAGNETIC PARTICLE TEST
BOROSCOPIC TEST
Is This Answer Correct ? | 1 Yes | 1 No |
placement papers for RNTBCI
can aluminium be welded?if so say the type used for it?
What is coefficient of contraction?
what should be the correct duration of slow firing of the coal based and biomass boiler?
In which reactor the coolant and moderator are the same ?
hi friends i am harish and i have a problem plz solve it . . The problem are how to calculate the rpm of mechanical blower if any formula for calculate for this then tell me if drive shaft gear are 40 teeth and driven shaft gear are 70
What are the causes of low compression in the main engine?
Is there a simple method to measure the horsepower of a small motor (1-3 hp) for a non-technical person?
What to write.. for perception about ntpc.. when you are applying for its interview?
how does thread of particular can be identified,how we can identify exact tap size for holes for example what is drill size for M6
what values do you consider important for professional success
Why in screw & centrifugal compressor using rolor bearing