what's interlock relay ?
- 3 Answers
- 5514 Views
- International Mega Food Park Limited, National Power Training Institute NPTI, I also Faced
- E-Mail Answers
Answer Posted / pvl
Interlock relay is a type of protection system which senses some event and triggers corresponding action.
For example, NC relay for power supply will keep the supply up normally, but as soon as some fault occurs, it will change to OPEN contact and cut the power supply to the system. This action is called interlock and therefore the relay is named interlock relay
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
operation
some one can tell me how residual type excitation is provided through transformers to an AC generator without any battery or PMG&excitor
what's the moog valve
How to calculate power press toneage
how to differentiate between "ALL fuel lost" and "All Fuel Lost" in Boiler MFT condition?
our 125 kva DG does not start in AUTO mode works normally in MANUAL mode please give me a solution.....
why is the in steam turbine axial displacement of active side thrust pad is positive and non active side thrust pad is negative.
what is the trip circuit supervision in an electrical meaning?
What is difference between secondary Air & Tertiary Air and Their use.?
Qatar Fertiliser Company (QAFCO) Shortlisted me for interview (got the intel from my source) for Field Operator- Utilities post. Please let me know what kind of questions they asked? ... this position requires 5 years of experience in Power Plant and background Diploma in Electrical/ Mech. ... my Background is Electrical and I am a sub Assistant Engineer (Operation) at a private HFO based Power plant... PS: Please Let me know what preparation should I take to obtain the Interview which will be take place In Bangladesh soon
why airtel use + 24 volts and other operators use -48 volt
DCS marshaling Cabinet Power supply can be replace during plant running time? Answer Yes it is possible. I am talking about the controller and cards power supply modules. They are always redundant and connected through diode so that if one power supply fails the other can take the charge immediately.so it is possible to replace one of them in running plant if the other one is healthy. MY question is how switching done.
Which will have more strain energy 1.Spring 2.Circular disc 3.Solid square plate.
im try to calculating seawater flow required for SW-FGD system. I need a guide, equation or method to do it, can some one help me! Thanks very much
LAPT working in alternator / generator
