How we are blocking 40 kg or more pressure through only 6 kg instrument air in c

How we are blocking 40 kg or more pressure through only 6 kg instrument air in control valve

Question Posted / dhananjayk

3 Answers
10197 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

How we are blocking 40 kg or more pressure through only 6 kg instrument air in control valve ..

there exists an inverse relationship between pressure (P) and the surface area (A).

Pressure=(Force/Area)
By manipulating The Force-Area Ratio we can achieve what you ask.
You only need to reduce appropriately the surface area on which the 6 Kg weight is acting to match the pressure created by the 40 Kg weight.

seunwole

Is This Answer Correct ?

9 Yes

0 No

How we are blocking 40 kg or more pressure through only 6 kg instrument air in control valve ..

Answer / arun kumar m

F=P*a
the diaphragm area is large to force the plug in 6ksc air.

Is This Answer Correct ?

3 Yes

0 No

How we are blocking 40 kg or more pressure through only 6 kg instrument air in control valve ..

Answer / farhan riaz

to increase the dia of diapharam plate

Is This Answer Correct ?

0 Yes

3 No

Post New Answer

More Instrumentation Interview Questions

Why ues 250 ohms Resistor during hart type instruments calibration with hart protocol in details ?

5 Answers

hello.my friends.i am an electronics & instrumentation engineer.i want to know Q1.why lugs use in instrumentation cable termination? Q2.if limit switch not working what to do?

2 Answers

How to make position transmitter feedback reverse i.e at valve close i want 20ma output and at full open 4ma.for the NELES positioner,model:ND8261/TS1.

3 Answers

Pressure tx shows 1 mbar but we need 1000 mbar at this process condition .. how can we sort it out .

0 Answers

How to calibrate displacer type level transmitter (chemtrol make )for level measurement in hotwell , LP & HP heater ?

0 Answers Matrix,

i want the equation of this question. Tranmitter range is 120 mmwc and dcs flow range is 1700 nm3/hr. if i want to change dcs range from 1700 to 2400 nm3/hr then how much dp i have to enter in transmitter

2 Answers GMR,

FOR CO/CO2/O2/NOX applications which of the following manufature is best? and what is the basic principle of gas analysers? ABB/YOKOGAWA/EMERSON/SIEMENS/TELEDYNE/THERMOFISHER

4 Answers

generally transmitter power supply having some range(12v to 35v) but the out put(4-20 mA) must same for given input.If we vary the power supply voltage then output mA also to be change according to V=IR. Is there any voltage regulator in the transmitter ?

1 Answers Indian Steel,

explain level transmitter working

1 Answers

what is the relation between flow and pressure.for example relationship between level and pressure is p = phg like that i want ans for this question.and also how to calculate orifice sizing and flow transmitter. pls some one ans for this questions.

3 Answers Orchid, SRF,

What is transmitter

2 Answers GNFC, QNFS,

pt range is -45 psi to 45 psi.friends can you give answer with calculation and with linerity scale like 0%,25%,50%,75%& 100%?

1 Answers WB,

For more Instrumentation Interview Questions Click Here