Answer / mnb

these logics are mainly seen in f&g system where signals from 2 sensors out of 3(2 out of 3) reaches preset value the system should shutdown or should do the actions programmed.
this can be used with any transmitters. Its main aim is to avoid unwanted shutdown.

What is difference between Ionization heat and bimetallic heat

0 Answers   KOC,

---

Can anybody please let me know Orifice plate sizing calculation formula and step by step procedure

0 Answers  

---

Different between control valve and mov

2 Answers  

---

whatis diference between zero pressure and obsolute pressure

1 Answers   ABB,

---

what are the installation requirement is common to all flow meter when volumetric flow rate is being measured

1 Answers  

---

wat are the interview questions asked in air india for post service engineer

1 Answers   AirIndia, Shree Renuka Sugars,

---

there are two candidates p and q in an election.During the campaign,40% of the voters promised to vote for P ,and rest for Q.however, on the day of election 15% of the voter went back on their promise to vote for P and instead voted for Q. 25% of the voters went back on their promise to vote for Q and instead voted for P.suppose,P lost by two votes,then what was the total no. of voters.

1 Answers   GATE,

---

how its work inductive proximity sensor explain briefly?

1 Answers  

---

What are Sinking and Sourcing IO Cards

2 Answers  

---

Difference HAZOP and HIRA

1 Answers  

---

What is the live zero and dead zero

2 Answers   Samsung,

---

How to Calibrate Vortex Flow transmitter in field

0 Answers  

---