how flame detectors sense the flame.
Answers were Sorted based on User's Feedback
Answer / k.chandra seakhar
the flame sensor is working depend upon the ultravilot rays
Is This Answer Correct ? | 8 Yes | 0 No |
Answer / sibapati acharya
Despite the type(which is dependent on frequncy range of
flame),the basic principle is that a concave lens is used
for directing the flame rays to a photo diode. the current
produced from the photo doide is condtioned for flame
detecting in BMS.
Is This Answer Correct ? | 10 Yes | 2 No |
Answer / nilesh karpe
There are 2 types of flame detectors in market viz: IR
(infra red ) and UV (ultravoilet ray).
Is This Answer Correct ? | 6 Yes | 0 No |
y v r connecting 250 ohms resistor in series when u cummunicate with BT in bench calibration?
In vortex flow meter how can measure the frequency of vortex generated by vortex flow meter
why we connect digital multimeter in series for dc current measurement and parallel for dc voltage measurement.
What is the use of each wire in three wire RTD
how will you segregate the alarm levels in alarm management system during factory Acceptance Test
if the neutral and ground of ups voltege are connected together in the source itslef then why the voltege b/w neutral and ground comes positive in some other destination inspite of having earth pit. how can we mimmise this?
what is the best method to measuring level in high pressure and temperture thank?
What do you do as a Engineering person EPC for Sizing&Selecting Control Valve?
what is the calibration standard for pressure and differential pressure transmitters?
how the presure switches are calibrated? and what happen inside?
What is Cavitation?
How to Calibrate Temperature Switch in field