Answer / praful

Mostly instruments are designed for 24v supply and 4to 20ma
output here we have 12v supply so resistance should be 125
ohms so we can make 550 ohms into 125 ohms by connecting
161ohms resistance in parallel for that we require 323mtr
cable.so we can use almost 300mtr cable. this is just my
practical assumption and i dont have any theoretical proof
for the same.

Answer / c heman

Assume it is a 4-20 ma tx. 20ma*550= 11volts. minimum
supply is required. so allowable voltage drop is only 1
volt.
so max. 100meter u can use.

got the answer, don,t foget to say thanks.

Answer / m. saqib ali nafees

thanx to all

Answer / c heman

100 meters max.

Answer / mun

wrong question

What is the principle of capacitance type level transmitter?

0 Answers  

what is skin type thermocouple? how it is installed? what is the difference b/w thermocouple & skin type thermocouple? what is gounded & non-grounded thermocoplle? what is the diff b/w these two?

2 Answers   KazStroy Engineering, PSU,

What is the GK Value in Flowmeter?

0 Answers   IBPIL, Thermax,

i want to control the temp of sand(welding flux) between the range of 150deg C to 170deg C. sugges me sum temp control method without PID controller.

1 Answers  

In my plant I want to mount a steam flow transmitter .Flow nozzel is already mounted in steam line .So how can i know the range to put in flow transmitter?

1 Answers  

What is output of Thermocouple at 25 deg c

10 Answers   TATA,

what is the difference between Cv and air consumption? why the customer needs Air consumption details?

0 Answers  

1. what is 3 point calibration & 5 point calibration? 2. If we use hart communicator to set the LRV & URV of a smart transmitter, did we calibrate the transmitter? why? 3. Make a complet list if meterials needed to properly connect a pressure gauge to a steam pipe using 1/2 inch stainless steel tubing. The gauge connections is 1/2 inch NPT-M and the steam pipe tap has a 1/2 inch female coupling, compression fittings are use. 4. What are the tools in loop checking? 5. What would the ISA symbol of a square root extractor look like? 6. What would you do to completely prepare for the configuration? 7. What safety measures must you undertake when doing configuration? 8. what are the two most commonly use programming languages used when we configure a PLC? 9. What would you do if you accidentally skipped a step in the configuration procedure? 10. How would you know if the configuration were sucessful? 11. Name at least 3 selections available when we configure the burnout protection of a controller?

3 Answers   EI Electrotechnical Institute,

In a ball valve which require 24v dc supply to operate, whose solenoid valve doesn't have any + or - indication, how can we make wiring connectionto solenoid valve?

1 Answers   Process Control Technologies,

TCD Principle

1 Answers  

What is instrumentation control?

0 Answers  

What is the difference between Analytical instruments and other instruments?

7 Answers   Schenck,