suppose MCC (Motor control center)panel work on field the relay on this damage

suppose MCC (Motor control center)panel work on field the
relay on this damage or not work and earth fault occurs in
this and no indication in relay panel given below. than MCB
trip or not and what effect the panel how find relay will
damage or not work.

Question Posted / vikram ahuja

2 Answers
4940 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

suppose MCC (Motor control center)panel work on field the relay on this damage or not work and eart..

Answer / vikram ahuja

please give answer

Is This Answer Correct ?

2 Yes

0 No

suppose MCC (Motor control center)panel work on field the relay on this damage or not work and eart..

Answer / chand

Check the supply to relay coil from either mcb or any positive from panel ,if the relay is energized check its contact (no/nc)from where we have the contact for indication .
If contact is not working change the relay base

Is This Answer Correct ?

1 Yes

1 No

Post New Answer

More Electrical Engineering Interview Questions

What is APFC Panel????

5 Answers Emerson,

Any formula to calculate neutral current in 3 phase 4 wire system

1 Answers

how do you test tachos and servos

0 Answers

what is the purpose of starter in tube light?what is it operation .

1 Answers

what is the max load on a 10 mva transformer & plz define it with its formula

0 Answers

being an electrical engineer why you wanna come into software i have an very good academics what answer i have to give

0 Answers

Why we use 4-20 mA Analog signal for the PLC input? Why not 0-20 mA? Why not 5-25 mA?

0 Answers

Why do power lines not short out when they fall into water?

0 Answers

11. As per the theory current doesn’t flows in Neutral, but practically it is not applicable, explain why? 12. How to take the Vector Group Test in Transformer? What is the purpose of doing Vector Group Test? 13. Why the transmission lines are in 11kV, 22kV, 33kv, and why not 10kV, 20kV, 30kV? 14. Why do we generate 3 Phase AC Supply? It is possible to generate 4 Phase and 5 Phase explain it? 15. Explain why the Voltage drop will happen in 3 Phase line? 16. What is the equipment used to control the generator output? 17. What are the factors to be considered during the Synchronization? 18. What should be value of Circuit breaker operating time and tripping time? 19. Why the CT Secondary is rated as 5A generally? 20. At which time Synchronous generator act as a Synchronous Condenser?

1 Answers

how can we phase identification in a distribution line,how we recognise that which phase is coming for a house hold connection.help me............

0 Answers

in electrical fire which group fier Extinguisher as used

6 Answers

what are the dimensions for 200 kva transformer plinth (plateform),in which pcc m20 is used..

1 Answers UPPCL,

For more Electrical Engineering Interview Questions Click Here