suppose MCC (Motor control center)panel work on field the
relay on this damage or not work and earth fault occurs in
this and no indication in relay panel given below. than MCB
trip or not and what effect the panel how find relay will
damage or not work.
- 2 Answers
- 4007 Views
- I also Faced
- E-Mail Answers
Answer Posted / vikram ahuja
please give answer
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What are root loci?
Formulae for calculating the transmission line losses for different voltage levels
why tertiary winding is used in transformer with diagram?
Can anybody please refer the best and simple book for about Protection relays and in detail of all its protection ?
What is cross over distortion? How it can be eliminated?
When are the directional relays used?
hi, in the event earth grounding is not available in a project, is there any other way to make the elcb work? fyi, i have an instant water heater (6.5kw) installed, however if there is grounding in the heating element inside the heater assembly, i will get grounded. thank you in advance to those who will answer my question.
in single phase converter, the no.of scr's conducting during overlap a)1 b)2 c)3 d)4
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
how to setting voltage RTCC panel
how to select electronic timer(Star-Delta) setting for diff. rating motors
how withstand of hi-pot test outputs of transformer wire 2.5mm
Differentiate between magnetic field and magnetic flux?
What is the role of feedback in a closed loop control system?
Work done in a free expansion process is
