Answer / iamdon

The major problem faced with emergency light is related to
battery.

1)Overcharging:For quick charging,charging done beyond the
rated current and voltage level which would had not been done.
2)Prolong operation at under charge state: May permanently
damage the electrodes of battery.
3)Incomplete wire connection. etc

If rest part is working fine then only option left is to
replace the battery with proper one.

Author:arbelectbit@yahoo.com

Answer / viki

Main problem is battery problem.This problem solved simply
by change another new battery.If we buy new battery means,
that problem will be solved.

What is Skin effect in Cable?

4 Answers  

---

when we have to use UPF wattmeter and LPF wattmeter? what is the difference between UPF and LPF wattmeter in terms of construction?

4 Answers  

---

Can you any one explain different between instantaneous over current and IDMT

1 Answers  

---

what clearance required for 4.5 mva dry type transformer?

0 Answers   SPS,

---

why we use copper earthing for neutral while for body GI.

1 Answers   Chennai Metro Rail Limited CMRL, Valeo Lighting Systems India Private Limited,

---

An ELHNC 80amp 240v 30mA RCD is tripping periodically, every 30 - 180 seconds is it safe to disconnect the protection circuit?

0 Answers   HAL,

---

why grid failure happens?

1 Answers  

---

what will be happen if earth point is being used for as a neutral point for raw power , and same will be used for ups earthing

0 Answers  

---

advantages and disadvantages of inverse definite minimum time RELAY

0 Answers  

---

Determine the minimum cable size for a 28A single phase final sub circuit originating from the distribution board supplied by three phase submain. The route length of the final sub circuit is 54 m. Assume 1% voltage drop in the consumer's mains. Submain specification: Cable: 50mm2 4 core V75 copper; Route length 42m; Maximum demand 135A per phase

1 Answers  

---

In a single phase converter, the no. of SCR conducting during overlap? a.1 b.2 c. 3 d. 4

3 Answers  

---

why a pilot exciter is used in combination with the main exciter? why not only a main exciter is used for excitation to an alternator?

1 Answers   Electrical,

---