Answer / anbu

Heavy leak
There is no way to maintain the required pressure so its better to stop the pump, otherwise power waste.

Light leak
If your pump running with VFD ( variable frequency device ) or scoop adjustments, then you can able to change your pump speed. If you increased means pressure and flow also increased at same time amps and power also increased.

What is the use of Hydraulic Coupling in-between BFP pump & BFP Motor?

1 Answers   Lanco, XYZ,

---

If a pump has "N" no .of conections in the discharge. If a connection has a heavy leakage. Then it's motor current get affected or not??

1 Answers  

---

what is absolute separator, how it works, what are the types in it

1 Answers  

---

if suppose boiler has high heavy tube leakage, so in which time we feed the water in a boiler. can we stop the feed water at particular combustion temperature.

4 Answers  

---

63.5 ohm NGR is connected with our gas engine genrator running at 500 rpm, 50 hz and synched with WAPDA at 6.3 KV bus voltages, 2500A and 25KA(1 sec). can some one give me proper calculations how it comes 63.5ohm?????

2 Answers   UET,

---

What are the special criteria under which FD fans are switched off during MFT.

1 Answers  

---

What happens if there is no HP and LP By-pass.

5 Answers  

---

Why reheater is not used after IP turbine.

3 Answers   Hindalco, SEC,

---

why Subcritical has 60% condenser capacity

1 Answers  

---

What happen when the AVR of the generator fails? Will it cause power instability and total failure of the alternator?

8 Answers  

---

.What is drip and drain.

2 Answers   NPTI,

---

What happens if air is present in LPH and HPH.

2 Answers  

---