Follow Our FB Page << CircleMedia.in >> for Daily Laughter. We Post Funny, Viral, Comedy Videos, Memes, Vines...

I am getting above 60 V as open delta voltage against single
phase unit ICT at tertiary delta formed and ICT getting
trippped on NDR. ICT tested and found in order. PTs provided
on tertiary are tested and in order. what may be the reason?

No Answer is Posted For this Question
Be the First to Post Answer

More Electrical Engineering Interview Questions

What is the latest generation of circuit breakers called?

why v/f ratio to maintain constant in speed control of induction motor?

1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.

Explain Even and Odd signals?

why florescent light was flickering?

What do you mean by linear and bilateral network?

whycircuit breaker is not connected at the generator end where the capacity of the generator is more say 60MW, 100MW etc.

Haw to check conductivity of budbar

which %age if losses increases when frequency is increased to 25%

what is invertor supply and raw powersupply

What is kvar?

1)we r having one problem .one dry type transformer(6.6KV/433V)is taking high magnetizing current on delta connected HV side of "U" phase when compared to other two phases.could any body tell the reason why it is happening? 2)why CT secondary side protection core has got higher winding resistance when compared to that of metering core of same CT?

Categories
• Civil Engineering (5080)
• Mechanical Engineering (4447)
• Electrical Engineering (16619)
• Electronics Communications (3915)
• Chemical Engineering (1093)
• Aeronautical Engineering (214)
• Bio Engineering (96)
• Metallurgy (361)
• Industrial Engineering (258)
• Instrumentation (2993)
• Automobile Engineering (332)
• Mechatronics Engineering (97)
• Marine Engineering (123)
• Power Plant Engineering (171)
• Textile Engineering (575)
• Production Engineering (0)
• Satellite Systems Engineering (106)
• Engineering AllOther (1378)