In an panel board if the outgoings are power plugs and motor equipments...what

In an panel board if the outgoings are power plugs and
motor equipments...what should we choose as the incomer of
the of the panel board?? MCCB OR ISOLATOR?? Should we use
ELCB protection??if so where??

Question Posted / vbn

2 Answers
4661 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

In an panel board if the outgoings are power plugs and motor equipments...what should we choose as..

Answer / vbn

Thnk u for ur answer sunil sir.but if we use mccb as
incomer..what we will do to protect the motor from earth
leakage??shoud we use an ELCB near to the motor equipmnt??or
should we use an ELR relay in mccb connected via cbct??

Is This Answer Correct ?

1 Yes

0 No

In an panel board if the outgoings are power plugs and motor equipments...what should we choose as..

Answer / sunil

we will use MCCB because when fuse melt of one phase the
motor will work on two phases in these case the MCCB will cut
off the supplly to the motor. ISOLATOR will not used because
its function is open or close the circuit on no load ond only
.

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

What is spike & surge.

2 Answers

in soft starter system for 375 KW 3 ph induction motor for multi stage vertical pump, two thyristers failed causing shorting of thyrister. the motor winding failed while starting.What is the cause and what is the effect in above case

1 Answers KPCL,

how much amps can i connect for 4core 120mm armade cable

2 Answers

What is the difference between MCCB, ACB & VCB

7 Answers

Electricty is generated at around 16kV, then step up to 220kV for transmission then steped down to power transformers then DTs and then through the LT n/w it reaches the consumer end. At the consumer end 230V supply is required. So, why is electricity not generated directly at 230V and transmitted?

4 Answers

What is bridge rectifier and explain with details

0 Answers

can we use IGBT as a AC-DC converting device in the applications?

2 Answers

In India the supply voltage is 230 volt A.C. During the negative half cycle phase becomes neutral and neutral become phase? or what will happen during negative half cycle? how the electrons flow during positive and negative half cycle?

0 Answers ITI,

what happen if one of 3-phase line has a much higher load when we are using delta to star transformer? how we can over-come from that?

2 Answers Getco,

tube light how its working.,?

3 Answers

what is the function of Choke?

9 Answers Airport Electrical, Cummins, Tamco,

11kv/0.433kv, 2 mva , transformer , for protection and metering how many CT/PT are required?

24 Answers Bhilai,

For more Electrical Engineering Interview Questions Click Here