Answer / ilyas

For a 100HP motor which equals to 74.58KW a transformer of
max capacity of 63kVA could be used...
As the maximum load at 0.8pf here would be equal to 59.664KW.

Answer / 7anoter4

See:

https://www.relayspec.com/catalogs/002050/2006/11-12.pdf

The error in a single phase energy meter where pressure coil lags behind applied voltage by 88 degrees and pf is 1) upf 2).5lag

1 Answers   GATE,

---

10 tube light connect in mcb breaker.one tube light is fault.so breaker is tribe.how fault is rectified.(using 3wire phase,earth,neutral)

0 Answers   CTS, Jindal,

---

what is the constructional difference between a power transformer and potentian transformer?

0 Answers   BTM,

---

What are the main parts of VCB?

12 Answers  

---

how to calculate fault level?

0 Answers   Mylan,

---

what are the industrail measures to over ferranti effect? how would the ferranti effect the power system if those remedial mearsure arent taken? how often does this effect occurs in real power system?

0 Answers  

---

why is  use the star and delta connection and difference

1 Answers  

---

What is Diff. btw Cat-5 & Cat-6 Network Cables???

3 Answers   Emerson,

---

what voltage to be select in megger for insulation resistance testing to L.V , H.T cables,motors and transfomer?and ohms valve should be giga ohms only or what?

1 Answers   Deevya Shakti Paper Mills,

---

On what basis primary and secondary of a transformer is chosen?

2 Answers  

---

How one can say about a device (e.g: a light holder contains 20 or 30 L.E.Ds which glows when power supply is off, from which source they are getting the supply..... battery or capacitor) without removing and opening up its case ?

1 Answers   CMC,

---

How u can give the overload setting to any motor protection relay for a HT motors with formula and Example?

0 Answers   OCL,

---