3) How earthing is done? How it measured? Write the method for earthing? How the earth resistance is kept low?
Answer / karna
Method of earthing is Pipe Earthing and Plate
Earthing .Earthing we are Provided for Electrical
components by using copper cable or copper flat etc..
Earthing can measure in Ohms by using earth tester. By
pouring water regularly, adding coal and salt for every six
months
Is This Answer Correct ? | 3 Yes | 2 No |
How to Calculate KA Rating of Main LT Panel
why dc series motor high speed motor
Define the overload capacity of the motor.
what is the difference between R Y B windings in three phase.does it differ by construction or by number of windings?Explain the difference between them.
IS THE ANY DIFFERENCE B/W GENERATORS & ALTERNATORS
how to combine two linear transformers...............
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
do you have some of interview Questions in power and genrator section in general whith answers
how can we run the induction motor at 9000 rpm ,by keeping frequency constant??
sir what is the purpose of SF6 in HT breaker and what is the pressure should be maintain in the breaker?
What is the following which is printed on electrical appratuses like AC21 ,AC 23 , etc ?
why secondary of open delta pt (two element pt) centre tap is earth what happen when this earth is removed